6 Types of Deep Foundations used in Construction and Their Uses

Gopal Mishra

11 years ago

Reading time: 1 minute

Deep foundation is required to carry loads from a structure through weak compressible soils or fills on to stronger and less compressible soils or rocks at depth, or for functional reasons. Deep foundations are founded too deeply below the finished ground surface for their base bearing capacity to be affected by surface conditions, this is usually at depths >3 m below finished ground level. Deep foundation can be used to transfer the loading to a deeper, more competent strata at depth if unsuitable soils are present near the surface.

Types of Deep Foundation

The types of deep foundations in general use are as follows:

Basements
Buoyancy rafts (hollow box foundations)
Caissons
Cylinders
Shaft foundations
Pile foundations

1. Basement foundation

These are hollow substructures designed to provide working or storage space below ground level. The structural design is governed by their functional requirements rather than from considerations of the most efficient method of resisting external earth and hydrostatic pressures. They are constructed in place in open excavations.

2. Buoyancy Rafts (Hollow Box Foundations)

Buoyancy rafts are hollow substructures designed to provide a buoyant or semi-buoyant substructure beneath which the net loading on the soil is reduced to the desired low intensity. Buoyancy rafts can be designed to be sunk as caissons, they can also be constructed in place in open excavations. Read More about Buoyancy rafts (hollow box foundations)

3. Caissons Foundations

Caissons are hollow substructures designed to be constructed on or near the surface and then sunk as a single unit to their required level.

4. Cylinders

Cylinders are small single-cell caissons.

5. Drilled Shaft foundations

Shaft foundations are constructed within deep excavations supported by lining constructed in place and subsequently filled with concrete or other pre-fabricated load-bearing units. Read more on Drilled Shaft foundations.

6. Pile foundations

Pile foundations are relatively long and slender members constructed by driving preformed units to the desired founding level, or by driving or drilling-in tubes to the required depth – the tubes being filled with concrete before or during withdrawal or by drilling unlined or wholly or partly lined boreholes which are then filled with concrete.