How do I remove a load bearing wall and extend (extension only on one side) the ground floor on a g+1 structure, and what will be the costing of this procedure?
Do you need to remove the ads? Become VIP Member
Join TheConstructor to ask questions, answer questions, write articles, and connect with other people. When you join you get additional benefits.
Log in to TheConstructor to ask questions, answer people’s questions, write articles & connect with other people. When you join you get additional benefits.
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
How do I remove a load bearing wall and extend (extension only on one side) the ground floor on a g+1 structure, and what will be the costing of this procedure?
Kuldeep Singh
Well, one way would be to
1) First lay the footings and colomns in the extension area
2) then knock of the wall
3) underpin or scaffold the beams/girders above the wall
4) drill into the outer face at the joints of beams, coloumns from where the extension is to be done
5) drive in new reinforcement bars onto the drilled holes and grout
6) bend them up to make a crank extension
7) do the same to the new colmns
8) put up the formwork for beams and cast them with crank reinforcement, put up the formwork for floors or roof and cast them in the same way
9) build walls, doors, panels, etc at the new open faces after extension.
PS : This is just a suggestion. It’s not tried and tested. For a cost estimate, a contractor or estimator might help.
Komal Bhandakkar
Removal of load bearing wall:
Thank You.
nikeetasharma
A floor plan should be provided with sections showing column and beam layout. But it will be better if you hire a contractor.