In the design of elastomeric bearings, why are steel plates inserted inside the bearings?
Join TheConstructor to ask questions, answer questions, write articles, and connect with other people. When you join you get additional benefits.
Log in to TheConstructor to ask questions, answer people’s questions, write articles & connect with other people. When you join you get additional benefits.
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
In the design of elastomeric bearings, why are steel plates inserted inside the bearings?
Komal Bhandakkar
Here, I am discussing some important reasons behind Steel plates inserted inside the bearing, especially in elastomeric bearings are as follows;
(Above diagram can clear your some doubts so refer it)
Kuldeep Singh
Steel plates are not inserted in elastomeric bearings, but they are embedded inside the rubber at the time of manufacture itself so as to assure that the plates are completely embedded having protection against corrosion, which could be a problem if they were inserted later. They are generally vulcanized or molded into the bearings like a multilayer sandwich, although the manufacturer may also connect the plates to the rubber via additional steel connectors.
The primary purpose of steel plates is to act as a reinforcement for the bearings against 1) vertical compression, 2) vertical compression with horizontal shearing, 3) vertical compression with horizontal rotation. They provide for higher resistances in the bearings by allowing limited horizontal deformations without failure at higher loads than the rubber itself.
Sometimes, steel plates are also used externally to provide resistance against high horizontal loads, but these plates aren’t completely or sometimes even partially embedded.
Madeh Izat Hamakareem
because it is responsible for a vertical stiffening effect and the simultaneous reduction in the rubber swelling.
Please visit the following link to read more about the bridge bearing:
https://theconstructor.org/structures/bridge-bearings-types-details/18062/